Danfoss 51 Series

Inspection
Inspect all parts for wear or damage. Replace worn or damaged parts.
G24
G260
G100
G3 6
F10*
F20*
G10
P101 229
Legend
for G24
use an 8 mm internal hex wrench
78 N•m [58 lbf•ft] for 80 cm³, 110 cm³, 160 cm³ motors
for G24
use a 10 mm internal hex wrench
110 N•m [81 lbf•ft] for 250 cm³ motors
for F10
use an 8 mm internal hex wrench
23 N•m [17 lbf•ft] for 60 cm³ motors
for F10
Service Manual
Series 51 and 51-1 Motors
Minor repair
48 |
©
Danfoss | March 2016 11008567 | AX00000013en-US0202