S6 low product temperature A
The S6 Product temperature has been below the min alarm limit for a longer time period than the set alarm
delay.
Alarm signal from digital input signal
Alarm signal from digital input signal
The controller manin switch has been set to either Stop or Manaual control. Alternatively a digital input set
up for "main switch" function, has stopped control
A case cleaning operation has been started on a case
The alarm temperature has been above the max alarm limit for a longer time period than the set alarm de-
lay.
The alarm temperature has been below the min alarm limit for a longer time period than the set alarm de-
lay.
CO
2
is leaking from the refrigerantion system
Refrigerant leak detected
Refrigerant is leaking from the refrigeration system
The humidity level is too high
The humidity level is too low
Inputs and outputs have not been congured correctly
The adaptive defrost function has detected heavy ice formation on evaporator.
The adaptive defrost function has detected heavy ash gas in front of injection valve
Max defrost time exceeded A
The last defrost cycle has stopped on time instead of set temperature
Alarm from digital input monitoring function
Alarm from digital input monitoring function
NOTE:
Data communication
The importance of individual alarms can be dened with a setting. The setting must be carried out in the group
"Alarm destinations"
© Danfoss | Climate Solutions | 2021.02 BC364229688105en-000101 | 63
AK-CC55 Single Coil and Single Coil UI
To Next Page
Loading...
Need help?
General
