Danfoss Ally User Manual

13
BC349733524454en-010401 © Danfoss | FEC | 2023.06 |
User Guide Danfoss Ally™ Radiator Thermostat
Screw the Danfoss Ally™ Radiator Thermostat onto the mounted adapter until a click sound
is heard. Once the thermostat is tightened properly, then adjust the display to your preferred
display orientation.
A large M is flashing in the display to indicate that installation mode is activated.
Press and hold the button for 3 seconds.
The temperature set point will show on the screen once the Danfoss Ally™ Radiator Thermostat
is mounted.
NOTE that you can find how-to videos on the Danfoss Ally™ support page and on YouTube.
6.6 Download the Danfoss Ally™ App
Download the Danfoss Ally™ App.
Danfoss Ally™
Youtube
Video Guide
6.7 Danfoss Ally™ Intelligence and automatic Adjustments
During the first week after installation, the Danfoss Ally™ Radiator Thermostat will automatically
begin to learn about and adjust itself to your heating system. During this process you
might experience that the thermostat reacts slowly or turns the heat up or down by itself.
The intelligence in the Danfoss Ally™ Radiator Thermostat requires this period of time to learn
about the heating system, and it is a normal and necessary part of the adjustment process.
1. Adjusting to the valve
During the first night of operation, the Danfoss Ally™ Radiator Thermostat will shut off the
radiator heat and then open again to detect the exact opening point of the valve. This will allow
the Danfoss Ally™ Radiator Thermostat to control the heat as efficiently as possible. If necessary,
the procedure is repeated once a night for up to a week.
2. Pre-heat
If you activate adaptive learning in your Danfoss Ally™ App, the Danfoss Ally™ Radiator
Thermostat spends the first week of operation detecting and learning when it is necessary
to start heating the room, in order to reach the correct temperature, at the correct time.
This intelligence will continuously adjust the heating time compared to seasonal temperature
changes.

Danfoss Ally Specifications

General

Accuracy	50 sec/month
Noise level	30 dB
Product color	White
Smart thermostat	Yes
Operating frequency	2400 MHz
Suitable for indoor use	-
Maximum water temperature	90 °C
Storage temperature (T-T)	-20 - 65 °C
Temperature control range	5 - 35 °C
Operating temperature (T-T)	0 - 40 °C
International Protection (IP) code	IP20
Package weight	250 g
Display type	LCD
Battery type	AA
Power consumption (typical)	1.2 W

Weight and Dimensions

Weight	198 g
Diameter	55 mm