Danfoss Eco Installation Guide

16
06/2015 VIJPD102 Danfoss Heating Solutions
User Guide eco Intelligent Radiator Thermostat
4. Temperature and programme settings
4.1 Setting the comfort temperature
1. 2.
If the display is off, press .
Use the buttons to raise or lower the comfort
temperature (default temperature 21 ° C). eco
will maintain the new comfort temperature
until the next setback or comfort period.
If the temperature is changed during a setback
period (default 17 ° C), the new temperature
will only be valid for this setback period.
For a permanent change of the setback tem-
perature, see chapter 4.3.
3. 4.
20 cm
If the comfort temperature is set at its lowest,
the MIN and temperature show, indicating the
minimum constant temperature.
eco is measuring the temperature with two
built-in sensors - one behind the display and
one near the valve.
Based on both readings the room tempera-
ture is calculated for an area approx. 20 cm in
front of the display. This allows eco to control
the actual room temperature very accurately.
Be aware that sources of cold or heat, e.g.
fireplace, direct sun or draft, might affect the
function of eco.
Note! If the set temperature is raised more than 1 °C eco will boost the radiator heat to reach the new
temperature faster. You can feel the valve and radiator are getting warmer.
Minor temperature changes will not evoke a heat boost, and so the changes are made without any
immediate indication.

Danfoss Eco Specifications

General

Package weight	250 g
Accuracy	50 sec/month
Noise level	30 dB
Certification	CE, ERC, EAC
Product color	White
Smart thermostat	-
Spindle movement	2 - 4.5 mm
Operating frequency	2400 MHz
Wireless connection	Yes
Maximum water temperature	90 °C
Storage temperature (T-T)	-20 - 65 °C
Temperature control range	4 - 28 °C
Operating temperature (T-T)	0 - 40 °C
International Protection (IP) code	IP20
Display type	LCD
Battery type	AA
Battery voltage	1.5 V
Power consumption (typical)	1.2 W
Number of batteries supported	2

Weight and Dimensions

Weight	100 g