1.7 Setting time and date for the rst time
1. 2.
When the batteries are installed the time
ashes on the display - 23:59.
a. Set hours with , press to confirm.
b. Set minutes with , press to confirm.
c. Set date with , press to confirm.
When ashes, press to confirm your
settings.
The display now switches to the Installation
Mode a large M flashes on the screen.
1.8 Installing eco
1. Note! Activate Installation Mode 2.
Ensure you are in Installation Mode before you
mount eco. If not, press for 4 seconds.
A large M is flashing in the display to indicate
that Installation Mode is activated.
3. 4.
Screw eco onto the adapter and tighten by
hand (max. 5 Nm).
While slightly pressing forward, turn eco
clockwise untill it locks, then tighten.
Press for 4 seconds to fix eco.
Installation Guide eco Intelligent Radiator Thermostat
To Next Page
Loading...
