Danfoss m2 - System Configuration via Key Pad; Entering Characters in Edit Fields; Passcode and Installation Name Setup

m2 Version 3.11 Manual RS.8A.N5.02 © Danfoss 10-2007 15
Conguring the System via the Key Pad
Entering Characters in Edit Fields
There are two types of character sets that are used in the m2 depending on
which edit eld has been selected:
Full Character Set
This is used in most of the edit elds. When the edit eld has been selected, the
characters within the set can be cycled through using the ‘ ’ or ‘ ’ keys. If the
‘ ’ key is pressed rst, it will start at ‘A’ and go forward through the character
set. If the ‘ ’ key is pressed rst, it will start at ‘z’ and go backwards through the
character set.
When a character has been selected, press either ‘ ’ to move to the next space
or ‘↵’ to move to the next edit eld.
Alphanumeric Character Set
If the ‘ ’ key is pressed rst, it will start at ‘0’ and go forward through the
character set. If the ‘ key is pressed rst, it will start at ‘z’ and go backwards
through the character set.
By pressing the ‘ ’ or ‘ ’ keys, the eld is incremented or decremented. By
pressing the ‘ ’ or ‘ ’ keys you can skip across the unit elds to make entering
larger numbers easier.
If your language uses Diacritics (accented characters), the m2 provides the
facility to enter these both from the local keypad and remotely via PC. This
facility is language sensitive such that only Diacritics which are relevant to the
language active on the unit are available. The method of entry is to select a
base character as normal and then add the required accent, e.g. in French if an
‘é’ is required the procedure is to rst select ‘e’ as described above, then enter
Diacritic mode and select the acute accent ´. To enter a Diacritic mode on a
suitable character, hold down the ‘ ’ like a shift key and press the ‘ ’ key once.
This will add the rst available accent to your character, any more which are
available can then be selected by pressing the ‘ and ‘ ’ keys together. When
the required accent is displayed, simply moving on to the next character stores
this and cancels the Diacritic mode. If you move the cursor onto an already
accented character, the unit will automatically enter Diacritic mode allowing you
to change the accent. Diacritic mode may be manually cancelled by pressing the
‘ ’ and ‘ ’ once more.
To congure the system via the key pad, select the Setup Menu option from the
Main Menu.
To change any of the conguration information via the keypad, you must rst
enter the correct password. The default passcode is 291. However, this may
have been changed to a passcode which is site specic.
Enter in the password using the ‘ ’ or ‘ ’ keys to cycle through the character
list and the ‘ ’ or ‘ ’ key to move the cursor left or right respectively. When the
password is complete, press ‘↵’.
The installation name is displayed on the Point Overview screen, the Alarm
History screen, the Event History screen and on the various printouts.
To set the installation name, select the Installation Name option from the Setup
Menu.
Numeric Only Fields
Diacritic Entry
Setup Menu
Entering the Passcode
Setting Installation Name