30 | © Danfoss | August 2018 AQ00000211
Installation
5.1 CONNECTOR INTERFACE
The PVED-CLS is only available with one connector variant: 12 pin Deutsch DT04-12PA-B016 connector
Figure 11
Important
Deutsch assembly and installation guidelines must be followed for connector and harness. Accordingly, Danfoss
recommends the use of lubricant (e.g. Nyogel 760G) on low-voltage electrical Connector contacts to further enhance the
robustness against wear (e.g. fretting corrosion). Severe vibrations are critical and should be avoided as they can affect
the lifetime of the connector.
To Next Page
Loading...
