Default Settings 60
Derating For Ambient Temperature 163
Derating For Installing Long Motor Cables Or Cables With Larger Cross-section 167
Derating For Low Air Pressure 166
Derating For Running At Low Speed 167
Digital In/out 115
Digital Inputs: 157
Digital Output 158
Display Line 1.1 Small, 0-20 70
Display Line 1.2 Small, 0-21 73
Display Line 1.3 Small, 0-22 73
Display Line 2 Large, 0-23 73
Display Line 3 Large, 0-24 73
Disposal Instruction 9
Drive Closed Loop, 20-** 94
E
Earthing And It Mains 21
Efficiency 161
Efficient Parameter Set-up For Water Applications 63
Electrical Installation 41
Electrical Wiring 48
Electronic Waste 9
Enclosure Knock-outs 19
End Of Curve Delay 100
End Of Curve Function 100
Etr 144
Ext. Closed Loop 128
F
Fault Messages 143
Fc Closed Loop 127
Fc Information 122
Filled Setpoint, 29-05 107
Final Ramp Time 79
Frequency Converter 45
Function Relay, 5-40 88
Fuses 20
G
General Settings, 1-0* 74
General Warning 4
Glcp 59
Graphical Display 51
H
How To Connect A Pc To The Frequency Converter 61
How To Connect Motor - Foreword 28
How To Connect To Mains And Earthing For B1 And B2 27
How To Operate Graphical Lcp (glcp) 51
I
Indexed Parameters 59
Indicator Lights (leds): 53
Initial Ramp Time, 3-84 78
Initialisation 60
Installation At High Altitudes 5
Intermediate Circuit 143, 161, 162
K
Keypad 59
Kty Sensor 144
Index
VLT
®
AQUA Drive
Operating Instructions
170
MG.20.M5.02 - VLT
®
is a registered Danfoss trademark
To Next Page
Loading...
Need help?
General