Read only
[0] 9.6 kbit/s
[1] 19.2 kbit/s
[2] 93.75 kbit/s
[3] 187.5 kbit/s
[4] 500 kbit/s
[6] 1500 kbit/s
[7] 3000 kbit/s
[8] 6000 kbit/s
[9] 12000 kbit/s
[10] 31.25 kbit/s
[11] 45.45 kbit/s
[255] No baud rate found
9-65 Profile Number
Range: Function:
Read only
0
*
[0 - 0] This parameter contains the profile identification. Byte 1 con-
tains the profile number and byte 2 the version number of the
profile.
NB!
This parameter is not visible via LCP.
9-70 Edit Set-up
Option: Function:
Select the set-up to be edited.
[0] Factory setup Uses default data. This option can be used as a data source to
return the other set-ups to a known state.
[1]
*
Setup 1 Edits Set-up 1.
[2] Setup 2 Edits Set-up 2.
[3] Setup 3 Edits Set-up 3.
[4] Setup 4 Edits Set-up 4.
[9] Active setup Follows the active set-up selected in par. 0-10.
This parameter is unique to LCP and fieldbuses. See also par. 0-11
Edit set-up
.
9-71 Save Data Values
Option: Function:
Parameter values changed via Profibus are not automatically
stored in non-volatile memory. Use this parameter to activate a
function that stores parameter values in the EEPROM non-vol-
2. Parameter Description VLT
®
AQUA Drive Programming Guide
122
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
2
To Next Page
Loading...
