EasyManuals Logo
Home>Danfoss>DC Drives>vlt aqua

Danfoss vlt aqua Programming Guide

Danfoss vlt aqua
298 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
[13] Infinite Automatic Re-
set
Select the reset function after tripping. Once reset, the frequen-
cy converter can be restarted.
Select
Manual reset
[0], to perform a reset via [RESET] or via
the digital inputs.
Select
Automatic reset x 1…x20
[1]-[12] to perform between
one and twenty automatic resets after tripping.
Select
Infinite Automatic Reset
[13] for continuous resetting af-
ter tripping.
NB!
The motor may start without warning. If the speci-
fied number of AUTOMATIC RESETs is reached
within 10 minutes, the frequency converter enters
Manual reset [0] mode. After the Manual reset is
performed, the setting of par. 14-20 reverts to the
original selection. If the number of automatic re-
sets is not reached within 10 minutes, or when a
Manual reset is performed, the internal AUTO-
MATIC RESET counter returns to zero.
NB!
Automatic reset will also be active for resetting
safe stop function in firmware version < 4.3x.
14-21 Automatic Restart Time
Range: Function:
10s
*
[0 - 600 s] Enter the time interval from trip to start of the automatic reset
function. This parameter is active when par. 14-20 is set to
Automatic reset
[1] - [13].
14-22 Operation Mode
Option: Function:
[0]
*
Normal operation
[1] Control card test
[2] Initialisation Use this parameter to specify normal operation; to perform
tests; or to initialise all parameters except par. 15-03, 15-04 and
15-05. This function is active only when the power is cycled to
the frequency converter.
Select
Normal operation
[0] for normal operation of the fre-
quency converter with the motor in the selected application.
Select
Control card test
[1] to test the analog and digital inputs
and outputs and the +10 V control voltage. The test requires a
test connector with internal connections. Use the following pro-
cedure for the control card test:
1. Select
Control card test
[1].
2. Disconnect the mains supply and wait for the light in
the display to go out.
2. Parameter Description VLT
®
AQUA Drive Programming Guide
146
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
2

Other manuals for Danfoss vlt aqua

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Danfoss vlt aqua and is the answer not in the manual?

Danfoss vlt aqua Specifications

General IconGeneral
BrandDanfoss
Modelvlt aqua
CategoryDC Drives
LanguageEnglish

Related product manuals