Danfoss vlt aqua Programming Guide

16-09 Custom Readout
Range: Function:
0.00
Custom-
Readou-
tUnit
*
[-999999.99 -
999999.99 Custom-
ReadoutUnit]
View the user-defined readouts as defined in par. 0-30, 0-31
and 0-32.
2.15.3. 16-1* Motor Status
Parameters for reading the motor status values.
16-10 Power [kW]
Range: Function:
0.0kW
*
[0.0 - 1000.0 kW] View the motor power in kW. The value shown is calculated on
the basis of the actual motor voltage and motor current. The
value is filtered, and therefore approx. 30 ms may pass from
when an input value changes to when the data read-out values
change.
16-11 Power [hp]
Range: Function:
0.00hp
*
[0.00 - 1000.00 hp] View the motor power in hp. The value shown is calculated on
the basis of the actual motor voltage and motor current. The
value is filtered, and therefore approx. 30 ms may pass from
when an input value changes to when the data read-out values
change.
16-12 Motor Voltage
Range: Function:
0.0V
*
[0.0 - 6000.0 V] View the motor voltage, a calculated value used for controlling
the motor.
16-13 Motor Frequency
Range: Function:
0.0Hz
*
[0.0 - 6500.0 Hz] View the motor frequency, without resonance dampening.
16-14 Motor Current
Range: Function:
0.00A
*
[0.00 - 0.00 A] View the motor current measured as a mean value, IRMS. The
value is filtered, and thus approx. 30 ms may pass from when
an input value changes to when the data read-out values
change.
2. Parameter Description VLT
®
AQUA Drive Programming Guide
162 MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
2

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled