Motor Nominal Speed, 1-25 14, 47
Motor Poles 49
Motor Power [hp] 13, 46
Motor Power [hp], 1-21 13, 46
Motor Power [kw], 1-20 13, 46
Motor Protection 53
Motor Rotation Check, 1-28 47
Motor Speed Direction, 4-10 70
Motor Speed High Limit [hz], 4-14 15, 71
Motor Speed High Limit [rpm], 4-13 15, 70
Motor Speed Low Limit [hz], 4-12 15, 70
Motor Speed Low Limit Rpm, 4-11 15, 70
Motor Speed Unit 26
Motor Start, 25-02 228
Motor Thermal Protection, 1-90 53
Motor Voltage 13, 46, 162
Motor Voltage, 1-22 13, 46
N
Net Control 10-15 129
Net Reference 10-14 129
Nlcp 21
No Trip At Inverter Overload 150
No-flow Delay, 22-24 198
No-flow Function, 22-23 198
Number Of Pumps, 25-06 229
Numbers Of Starts, 15-08 153
O
Obw Time, 25-25 232
On Reference Bandwidth, 20-84 184
Operating Hours, 15-00 152
Operating Mode 27
Operating State At Power-up (hand) 27
Operation Mode, 14-22 146
Option Ident. 15-6* 160
Option Mounted, 15-60 160
Option Ordering No, 15-62 160
Option Serial No, 15-63 160
Option Sw Version, 15-61 160
Ordered Type Code String, 15-44 158
Output Filter, 14-55 150
Over Temps, 15-04 152
Over Volts, 15-05 152
Overmodulation, 14-03 144
Override Bandwidth, 25-21 230
Over-voltage Control, 2-17 60
P
Parameter Access 130
Parameter Info, 15-9* 160
Parameter Metadata, 15-99 160
Parameter Options 257
Parameter Selection 19
Parameter Set-up 10
Pcd Write Configuration, 9-15 115
Period Start, 23-51 220
Period Stop, 23-52 220
Personal Menu Password 41
Pid Anti Windup, 20-91 184
Pid Auto-tuning, 20-79 182
Pid Auto-tuning, 21-05 187
Pid Controller, 20-9* 184
Pid Diff. Gain Limit, 20-96 185
Pid Differentiation Time, 20-95 185
Index VLT
®
AQUA Drive Programming Guide
294
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
To Next Page
Loading...
Need help?
General
