Danfoss vlt aqua Programming Guide

[170] psi
[171]
lb/in
2
[172] in WG
[173] ft WG
Power:
[180] HP
0-31 Custom Readout Min Value
Range: Function:
0.00
*
[0 - par. 32] This parameter allows the choice of the min. value of the custom
defined readout (occurs at zero speed). It is only possible to
select a value different to 0 when selecting a linear unit in
Cus-
tom Readout Unit
, par. 0-30. For Quadratic and Cubic units the
minimum value will be 0.
0-32 Custom Readout Max Value
Range: Function:
100.00
*
[Par. 0-31 -
999999.99 ]
This parameter sets the max value to be shown when the speed
of the motor has reached the set value for
Motor Speed High
Limit
, (par.4-13/4-14).
0-37 Display Text 1
Option: Function:
In this parameter it is possible to write an individual text string
for display in the LCP or to be read via serial communication. If
to be displayed permanently select Display Text 1 in par. 0-20,
0-21, 0-22, 0-23 or 0-24,
Display Line XXX . Use the ▲ or ▼ but-
tons on the LCP to change a character. Use the ◀ and ▶ buttons
to move the cursor. When a character is highlighted by the cur-
sor, it can be changed. Use the ▲ or ▼ buttons on the LCP to
change a character. A character can be inserted by placing the
cursor between two characters and pressing ▲ or ▼.
0-38 Display Text 2
Option: Function:
In this parameter it is possible to write an individual text string
for display in the LCP or to be read via serial communication. If
to be displayed permanently select Display Text 2 in par. 0-20,
0-21, 0-22, 0-23 or 0-24,
Display Line XXX . Use the ▲ or ▼ but-
tons on the LCP to change a character. Use the ◀ and ▶ buttons
to move the cursor. When a character is highlighted by the cur-
sor, this character can be changed. A character can be inserted
by placing the cursor between two characters and pressing ▲ or
▼.
2. Parameter Description VLT
®
AQUA Drive Programming Guide
38 MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
2

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled