Danfoss vlt aqua Programming Guide

2.2.10. Time Zone Offset, 0-73
0-73 Time Zone Offset
Range: Function:
0.00
*
[ -12.00 - 13.00] Sets the time zone offset to UTC, this is needed for automatic
DST adjustment.
0-74 DST/Summertime
Option: Function:
Choose how Daylight Saving Time/Summertime should be han-
dled. For manual DST/Summertime enter the start date and end
date in par. 0-76 and 0-77.
[0]
*
OFF
[2] Manual
0-76 DST/Summertime Start
Range: Function:
2000-01
-01
00:00
*
[2000-01-01 00:00 –
2099-12-31 23:59 ]
Sets the date and time when summertime/DST starts. The date
is programmed in the format selected in par. 0-71.
0-77 DST/Summertime End
Range: Function:
2000-01
-01
00:00
*
[2000-01-01 00:00 –
2099-12-31 23:59 ]
Sets the date and time when summertime/DST ends. The date
is programmed in the format selected in par. 0-71.
0-79 Clock Fault
Option: Function:
Enables or disables the clock warning, when the clock has not
been set or has been reset due to a power-down and no backup
is installed.
[0]
*
Disabled
[1] Enabled
0-81 Working Days
Array with 7 elements [0]-[6] displayed below parameter number in display. Press OK and
Step between elements by means of ▲ and ▼ buttons on the LCP.
Set for each weekday if it is a working day or a non-working
day. First element of the array is Monday. The working days are
used for Timed Actions.
[0] No
[1]
*
Yes
VLT
®
AQUA Drive Programming Guide 2. Parameter Description
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark 43
2

Danfoss vlt aqua Specifications

General

Supply Voltage	200-240V, 380-500V, 525-600V
Enclosure	IP20
Features	Energy optimization
Approvals	CE, UL, cUL
Input Voltage Range	200-240V, 380-500V, 525-600V
Output Voltage Range	0 to supply voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Short circuit, Ground fault
Communication Interfaces	PROFIBUS
Cooling Method	Air-cooled