Danfoss vlt aqua - Page 64

3-17 Reference 3 Source
Option: Function:
Select the reference input to be used for the third reference
signal. Par. 3-15, 3-16 and 3-17 define up to three different ref-
erence signals. The sum of these reference signals defines the
actual reference.
This parameter cannot be adjusted while the motor is running.
[0]
*
No function
[1] Analog input 53
[2] Analog input 54
[7] Frequency input 29
[8] Frequency input 33
[20] Digital pot.meter
[21] Analog input X30-11
[22] Analog input X30-12
[23] Analog Input X42/1
[24] Analog Input X42/3
[25] Analog Input X42/5
[30] Ext. Closed Loop 1
[31] Ext. Closed Loop 2
[32] Ext. Closed Loop 3
3-19 Jog Speed [RPM]
Range: Function:
300
RPM
*
[0 - 60000 RPM] Enter a value for the jog speed n
JOG
, which is a fixed output
speed. The frequency converter runs at this speed when the jog
function is activated. The maximum limit is defined in par. 4-13
Motor Speed High Limit (RPM ).
See also par. 3-80.
2. Parameter Description VLT
®
AQUA Drive Programming Guide
64 MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
2