display on the LCP, digital preset speeds, scaling of analog references, closed loop single zone
and multi-zone applications and specific functions related to water and wastewater applications.
The Quick Menu parameters can be accessed immediately unless a password has been created
via par. 0-60, 0-61, 0-65 or 0-66.
It is possible to switch directly between Quick Menu mode and Main Menu mode.
[Main Menu]
is used for programming all parameters.
The Main Menu parameters can be accessed immediately unless a password has been created via
par. 0-60, 0-61, 0-65 or 0-66. For the majority of water and wastewater applications it is not
necessary to access the Main Menu parameters but instead the Quick Menu, Quick Setup and
Function Setups provides the simplest and quickest access to the typical required parameters.
It is possible to switch directly between Main Menu mode and Quick Menu mode.
Parameter shortcut can be carried out by pressing down the [Main Menu] key for 3 seconds.
The parameter shortcut allows direct access to any parameter.
[Alarm Log]
displays an Alarm list of the five latest alarms (numbered A1-A5). To obtain additional details about
an alarm, use the arrow keys to manoeuvre to the alarm number and press [OK]. Information is
displayed about the condition of the frequency converter before it enters the alarm mode.
[Back]
reverts to the previous step or layer in the
navigation structure.
[Cancel]
last change or command will be cancelled as
long as the display has not been changed.
[Info]
displays information about a command, pa-
rameter, or function in any display window.
[Info] provides detailed information when
needed.
Exit Info mode by pressing either [Info],
[Back], or [Cancel].
VLT
®
AQUA Drive Programming Guide 1. How to Programme
MG.20.O2.02 - VLT
®
is a registered Danfoss trademark
7
1
To Next Page
Loading...
Need help?
General