Danfoss VLT Compressor Drive CDS 803 - IP21;TYPE 1 Enclosure Kit

Step 4
Connect cable to frequency converter.
130BB778.10
Illustration 3.4 Connect Cable
NOTICE
To fasten connector to the frequency converter, use the
provided thread cutting screws, tightening torque 1.3
Nm.
3.1.3 IP21/TYPE 1 Enclosure Kit
IP21/TYPE 1 is an optional enclosure element available for IP20 units.
If the enclosure kit is used, an IP20 unit is upgraded to comply with enclosure IP21/TYPE 1.
130BB902.12
A
B
C
OK
Alarm
Warn.
On
B
a
c
k
Hand
On
Reset
Auto
On
Status
Quick
Menu
Main
Menu
Illustration 3.5 H3–H5
Enclosure Cooling capacity Height [mm/
(in)] A
Width [mm/
(in)] B
Depth [mm/
(in)] C
IP21 kit
ordering
number
Type 1 kit
ordering
number
– 3x200–240 V 3x380–480 V – – – – –
H3 – 4–5 TR 346 (13.6) 106 (4.2) 210 (8.3) 132B0214 132B0224
H4 4–5 TR 6.5 TR 374 (14.7) 141 (5.6) 245 (9.6) 132B0215 132B0225
H5 6.5 TR – 418 (16.5) 161 (6.3) 260 (10.2) 132B0216 132B0226
Table 3.4 Enclosure Kit Specications
Selection Design Guide
MG18N202 Danfoss A/S © 12/2015 All rights reserved. 25
3 3