Danfysik 9700 - Installation; Important Safety Information

System 9700 User Manual
Page 11 of 56
2.4. Installation
Before and during installation of the power supply, the following points should be checked /
carried out.
 Check that the main voltage and frequency matches to the specified and labelled
requirements.
 Check that screw connections from the output terminals are tightened.
 Check that all screws on D-sub connectors are tightened.
 If the magnet is provided with a thermal breaker, connect the contacts to external interlocks
and +24 VGND (Ground for +24 V).
Unused external interlocks shall be connected to +24V ground (Ground for +24 V pin 12,
X112 or to pin 11 +24V_Ext_GND if +24V_Ext, pin X8 is used for interlock supply)
2.4.1. Important safety information
GENERAL HAZARD
Indicates a potentially hazardous general situation. The keyword (DANGER,
WARNING, and CAUTION) indicates the hazard level.
ELECTRICITY
Indicates a potentially hazardous electrical situation. The keyword (DANGER,
WARNING, and CAUTION) indicates the hazard level.
MAGNETIC FIELD
Indicates a potentially hazardous magnetic field situation. The keyword (DANGER,
WARNING, and CAUTION) indicates the hazard level.