Danfysik 9700 - Troubleshooting

System 9700 User Manual
Page 53 of 56
7. Troubleshooting
WILL NOT GIVE FULL OUTPUT CURRENT BUT NO ERROR
 Check that the link cable between the control unit and the slave units are connected.
WILL NOT GIVE MAIN POWER ON:
 Check for interlocks.
o Failure on control board, contact DANFYSIK Service.
PHASE FAIL INTERLOCK:
 Check all phases.
 Check AC main power voltage
REGULATION FAILURE INTERLOCK:
o Failure on regulation board or AUX-supply, contact DANFYSIK Service.
MPS OVER TEMPERATURE INTERLOCK:
 Check ambient temperature:
o Temperature higher than 40 °C: Ambient temperature must drop.
MAGNET TEMPERATURE INTERLOCK:
 Check connections to magnet.