Page 12 of 56
2.5. General Warnings
Please review the following safety precautions and all warning and caution information
throughout the manual.
WARNING!
This Magnet Power Supply (MPS) is intended for professional incorporation into
complete accelerator systems as a part of a fixed installation. If installed
incorrectly it may present a safety hazard. Close attention is required to system
design and electrical installation to avoid hazards in either normal operation or in
the event of equipment malfunction.
WARNING!
Do not perform any flash test or voltage withstand test on the Magnet Power
Supply. Any electrical measurements required must be carried out with power
supply disconnected.
CAUTION!
Only qualified electricians are allowed to install and maintain this equipment.
CAUTION!
Only DANFYSIK approved service technicians is allowed to open this equipment.
Do not remove covers or disassemble the unit. The Power Supply contains no user
serviceable components or adjustments inside the unit.
DANGER! ELECTRIC SHOCK HAZARD!
Disconnect power at the switchboard before attempting to work on the Magnet
Power Supply. High voltages are present at the terminals and within the power
supply for up to 10 minutes after disconnection of the electrical supply. Always
ensure by using a suitable measuring device that no voltage is present prior to
commencing work.
CAUTION!
Ensure correct grounding connection. The grounding cable must be selected to be
able to carry the maximum supply fault current. This is normally limited by fuses
at the switchboard. Fuses at the switchboard must be selected according to local
legislation or code.
To Next Page
Loading...
