Page 8 of 56
1.3. Warranty and disclaimer
DANFYSIK A/S warrants that the products manufactured by us will be free from defects in
material and workmanship that would adversely affect the normal functioning of the unit for a
period of 18 months from the date of shipment or 12 months from the date of installation
whichever occurs first.
The exceptions to this are:
a) Parts not manufactured by DANFYSIK A/S which are covered by the original
equipment manufacturer's warranty.
b) Repair work, which is warranted for six (6) months from the date of shipment from the
DANFYSIK works.
DANFYSIK A/S will repair or replace either on site or at the factory and without charge, any
equipment that proves to be defective within its warranty period.
In the case of warranty, DANFYSIK A/S will pay or reimburse lowest freight rate (two-way) of
any item returned to DANFYSIK or our designated agent/representative, provided that prior
written authorisation for such return has been given by DANFYSIK A/S.
This warranty shall not apply to any equipment that has become defective or unworkable due
to mishandling, improper maintenance, incorrect use, radiation damage or any other
circumstance not generally acceptable for equipment of a similar type.
On standard products, DANFYSIK A/S reserves the right to make changes in design without
incurring any obligation to modify previously manufactured units.
The foregoing is the full extent of this warranty, and no other warranty is expressed or implied.
In no event shall Danfysik be liable for special damages arising from the delivery, late delivery
or use of the equipment.
If any fault develops, the following steps should be taken:
Notify DANFYSIK A/S, providing full details of the problems, and include model type and serial
number.
On receipt of this information, DANFYSIK A/S will give you either service information or
instructions for shipping.
All shipments of DANFYSIK equipment should be made according to our instructions and
shipped in the original or a similar container.
For smaller parts, a carton will be sufficient, if the parts are wrapped in ESD bags and
surrounded with at least 10 centimetres of shock absorbing material.
To Next Page
Loading...
