DATA PRECISION 1350 User Manual

62-5008
MODEL 1350
3.3 CALIBRATION PROCEDURE
a. Use test and measurement standards witti specified performance
equal to or better tfian those shown in the table below.
PARAMETER SPECIFICATION
SUGGESTED
MFG./MODEL NO.
Frequency
(Measure)
@ 40 KHz ± 0.5% with
Zin ± 10 MO probe
Data Precision/585
Tektronix Probe/010-0192-00
DC Voltage
(Generate)
0to10V± 0.05%
Analogic/3100
Perform calibration in sequence below,
b. Time Base Calibration
(1) Reconnect ac power to Model 1350. Turn power ON. Observe
CAUTION!
(2) Connect frequency counter, high impedance probe, and Model 1350
as shown in Figure 3-2. Locate Z2-38 as identified in Figure 3-1.
(3) Adjust R15 (Figure 3-1) until measured frequency is 40KHz ± 0.5%.
(4) Remove probe.
FREQUENCY
COUNTER
(MODEL 5851
HIGH IMPEDANCE
MODEL 1350 DMM
PROBE
>
Z2-38
Figure 3-2. Time Base Calibration Setup
-^Copyright 1977. Data Precision Corporation. All rig
3-3

DATA PRECISION 1350 Specifications

General

Brand	DATA PRECISION
Model	1350
Category	Multimeter
Language	English