6 Owner’s Manual
Changing the Password
The command for unlocking the cover is *0. The default password for the system
as shipped from the factory is 000. The cover can be unlocked by keying the
following sequence *0 0000.
To change the password, do the following:
*1[0000][5555]
Old Password New Password
Change Password Code
Enter *1 (change password code) followed by the current password and then the
new password. For example, to change the default password 0000 to 5555, enter
*100005555. In this example, the keystrokes to open the Top Cover again using
the new password would be *05555.
If you do not remember your current password, use the key or contact your
Datacard Service Representative to reset it.
To Next Page
Loading...
