DataCard SD360 - Install the 200-Card Input Hopper

10 Installation
Install the 200-Card Input Hopper
Thestandardinputhoppercanholdabout1000.030in.(0.7 62mm)car ds.The
printerscanbeupgradedtousea200‐cardinputhopper.
The200‐cardinputhopperkitincludesthelargerhopperwithanattachedcover.
Thestandardhopperiseasilyremovedandthe200‐cardhoppercanbeinstalled
withoutusingtools.Youalsocanrefertotheinstructionsshippedwiththe
200‐cardinputhopperkit.
1. Opentheinputhopper.
2. Pressthereleasetab
locatedonthebackwall
ofthehopperwhi le
liftingthehopperupand
offtheprinter.
3. Installthe200‐cardinput
hopperbyaligningthe
tabswiththeslotsonthe
printer.
4. Pushthehopperdown
untilitclicksintoplace.
5. Loadupto200cardsin
thehopperandclosethe
hoppercover.The
printerisreadytoprint
cards.
Hopper Release Tab