DataCard SD360 - Cards; Card Size; Card Material; Pre-Punched Cards

84 Supplies and Parts
Cards
Forbestresults,usehigh‐qualitycardsthatmeetthespecificationsand
recommendationsdescribedinthissection.
Card Size
UseISOID‐1cards(CR80cards).Thesecardshavethefollowingdimensions:
• 3.37incheslongby2.125incheswide(85.60mmlongx53.98mmwide).
• 0.010to0.030inchesthick(0.254mmto0.762mmthick).
Forencodingmagneticstripe,use cards:
• 3.37incheslongby2.125incheswide(85.60mmlongx53.98mmwide).
• 0.010to0.030inchesthick(0.508mmto0.762mmthick).
Actualcardthicknesscanvarybyuptotenpercentfromthesizeslisted.Typically,
cardbowmustbelessthanthethicknessofthecard.
Card Material
UsecardswithaglossyPVCsurface,either100%PVCcardsorcompositecards
withaPVCsurface.Cardscanhaveamagneticstripeononesideofthecard.
Pre-Punched Cards
Forbestresults,punchcardsafter
printingthem.Thecardscanhave
apunchedareawithin1inch
(25 mm)oftheleftedge,asthe
cardsareloadedintheprinter.If
thecardhasamagneticstripe,
thecardcannotbepunched
anywhereinthestripe.