DataCard SD360 - Page 83

SD Series Installation and Administrator’s Guide 75
Clean the Printer
1.
Unlockthesystem,ifnecessary.
2. Removethesupplies.
A. Openthe printer’stopcoverandremovetheribboncartridge.
B. Removeanyblankcar dstockfromtheinputhopper.
C. Locktheprinter.
3. Placetheunwrappedcleaningcardinthecardinputhopper.
4. SelectMaintenance>Cleaning.
5. SelectCleanPrinter.
6. ClickRuntostartthecleaningprocess.PresstheUSERbuttonontheprinter
whenthemessage“172:Insertcleaningcard”displaysontheLCDpanel.
Theprinterpicksthecleaningcard,movesitthroughtheprinterseveraltimes,
andejectsitintheoutputhopperorrejectcardtray.
7. Removetheusedcleaningcard.Waitafewminutesfortherollerstodry.
8. Replacethesupplies.
A. Placethecardsintheinputhopper.
B. Replacethecleaningsleevewithanewsleeveandremovetheprotective
cover.
C. Replacetheribboncartridgeandclosetheprintercover.Locktheprinter,
ifnecessary.
Clean the Laminator
1.
SelectCleanLaminatorontheMaintenance>Cleaningpage.
2. ClickRun.
TheprinterLCDpaneldisplaystheme ssage“172:Insertcleaningcard.”
3. Insertthelaminatorcleaningcardintothecardexitslotofthelaminatorand
presstheUSERbutton.
Thelaminatorpullsthecleaningcardfromthecardexitslotintothelaminator
andmovesitbackandforththroughtheL1andL2cartridgeareasandthe
cardentryareaseveraltimes.Theusedcardisejectedintothelaminator
outputhopper.