D-500 MK2 User Manual Firmware V-6.3
- 93 -
In order to resume to the factory set parameter values:
-hold pressed the OFF, LAMP TEST and ALARM MUTE buttons for 5 seconds,
-“RETURN TO FACTORY SET” will be displayed
-immediately press and hold pressed the RIGHT ARROW button for 5 seconds
-factory set values will be reprogrammed to the parameter memory.
Hold pressed OFF, LAMP TEST and ALARM MUTE
Hold pressed RIGHT ARROW
The program mode is used to adjust timers, operational limits and the configuration of the unit.
Although a free PC program is provided for programming, every parameter may be modified through the front
panel, regardless of the operating mode.
When modified, program parameters are automatically recorded into a non-erasable memory and take effect
immediately.
The program mode will not affect the operation of the unit. Thus programs may be modified anytime, even
while the genset is running.
To Next Page
Loading...
Need help?
General
