EasyManuals Logo

Datakom D-500 MK2 User Manual

Datakom D-500 MK2
197 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #158 background imageLoading...
Page #158 background image
D-500 MK2 User Manual Firmware V-6.3
- 158 -
COMMAND
DESCRIPTION
ANSWER
GET IP
If GPRS connection is
active, the controller will
reply by an SMS message
indicating the IP address of
the GSM modem.
GPRS 1
Activates the GPRS
connection
GPRS 0
Stops the GPRS connection
RESET
ALARMS
Clears alarms of the controller.
The operating mode is not
modified.
REBOOT
Performs a hard reset on the
controller
no answer
MODEM RESET
Performs a hard reset on the
modem
no answer
GET INFO
Returns the alarm list and
actual measured values
ALARMS (if exists)
GEN: Vavg/ıAVG/kWtot/pf/Freq
MAINS: Vavg/ıAVG/kWtot
OIL_PR/TEMP/FUEL%
SMS messages must be written exactly as below, without any preceding blanks.
Only UPPERCASE characters are permitted.
SMS messages are accepted only from phone numbers recorded in the
Communication>GSM>Message Numbers tab.
Answers to SMS messages will be sent to all phone numbers in the list.
Alarms cleared!
GPRS disabled!
GPRS enabled!
IP: 188.41.10.244
28. SMS COMMANDS

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datakom D-500 MK2 and is the answer not in the manual?

Datakom D-500 MK2 Specifications

General IconGeneral
BrandDatakom
ModelD-500 MK2
CategoryController
LanguageEnglish

Related product manuals