D-500 MK3 User Manual Firmware V-14.2
- 10 -
35. DATA RECORDING
35.1. DATA RECORDING MEDIA
35.2. DIRECTORY STRUCTURE
35.3. UNDERSTANDING THE CSV FORMAT
35.4. RECORDED DATA LIST, RECORD PERIOD
36. SOFTWARE FEATURES
36.1. LOAD SHEDDING / DUMMY LOAD
36.2. LOAD ADD / SUBSTRACT
36.3. FIVE STEP LOAD MANAGEMENT
36.4. REMOTE START OPERATION
36.5. DISABLE AUTO START, SIMULATE MAINS
36.6. BATTERY CHARGING OPERATION, DELAYED SIMULATE MAINS
36.7. DUAL GENSET MUTUAL STANDBY OPERATION
36.8. MULTIPLE VOLTAGE AND FREQUENCY
36.9. SINGLE PHASE OPERATION
36.10. EXTERNAL CONTROL OF THE UNIT
36.11. AUTOMATIC EXERCISER
36.12. WEEKLY OPERATION SCHEDULER
36.13. ENGINE HEATING OPERATION
36.14. ENGİNE IDLE SPEED OPERATİON
36.15. ENGINE BLOCK HEATER
36.16. FUEL PUMP CONTROL
36.17. GAS ENGINE FUEL SOLENOID CONTROL
36.18. PRE-TRANSFER SIGNAL
36.19. CHARGING THE ENGINE BATTERY
36.20. EXTERNALLY CONTROLLED DIGITAL OUTPUTS
36.21. COMBAT MODE
36.22. RESETTING THE CONTROLLER
36.23. AUTOMATIC CONNECTION TOPOLOGY DETERMINATION
36.24. ZERO POWER AT REST
37. MODBUS COMMUNICATIONS
37.1. PARAMETERS REQUIRED FOR RS-485 MODBUS OPERATION
37.2. PARAMETERS REQUIRED FOR MODBUS-TCP/IP VIA ETHERNET
37.3. DATA FORMATS
38. SNMP COMMUNICATIONS
38.1. PARAMETERS REQUIRED FOR SNMP VIA ETHERNET
38.2. SNMP TRAP MESSAGES
To Next Page
Loading...
Need help?
General
