Datakom D-500 MK3 - Snmp Parameters

D-500 MK3 User Manual Firmware V-14.2
- 147 -
Parameter Definition
Factory Set
Description
V3 Security Level
AuthPriv
This is the parameter to enable authentication based
on SHA or MD5.
V3 Authentication
Algorithm
SHA
This is the parameter to define authentication method.
V3 Encryption
Algorithm
DES
This is the parameter to define encryption method.
V3 Authentication
Password
12345678
This is the password to authenticate snmp v3.
V3 Encryption
Password
12345678
This is the password to encrypt snmp v3.
V3 Username
datakom
This is the username to configure snmp v3.
V3 Context Name
-
This is the parameter to specify the name of the
context.
Community
public
Authentication password of get request.
Community Write
private
Authentication password of set request
Community Trap
public
Authentication password of trap messages
Trap Destination 1 IP
0.0.0.0
Destination IP address 1 to send trap messages
Trap Destination 2 IP
0.0.0.0
Destination IP address 2 to send trap messages
Trap Destination 3 IP
0.0.0.0
Destination IP address 3 to send trap messages
Trap Destination 4 IP
0.0.0.0
Destination IP address 4 to send trap messages
Trap Version
V3
This is the parameter to define snmp version of trap
messages.
Trap Destination 1
Enabled
1
This is the parameter to enable trap 1 destination
address
Trap Destination 2
Enabled
1
This is the parameter to enable trap 2 destination
address
Trap Destination 3
Enabled
1
This is the parameter to enable trap 3 destination
address
Trap Destination 4
Enabled
1
This is the parameter to enable trap 4 destination
address
17.19. SNMP PARAMETERS