Datakom D-500 MK3 User Manual

D-500 MK3 User Manual Firmware V-14.2
- 125 -
In AUTO mode, it is possible to define the periods where automatic operation is desired. It may be
required that the genset does not start at night or weekends.
Weekly schedule programs allow an hourly setting of automatic operation of the unit during one week.
There are 7days x 24hours =144 parameters. Each hour of the week can be independently defined as
AUTO or OFF period.
If automatic operation is disabled by the weekly
exerciser, the AUTO led will flash.
17.5. WEEKLY OPERATION SCHEDULE

Datakom D-500 MK3 Specifications

General

Brand	Datakom
Model	D-500 MK3
Category	Controller
Language	English