Datakom D-500 MK3 - Page 7

D-500 MK3 User Manual Firmware V-14.2
- 7 -
5. TOPOLOGIES
5.1. SELECTING THE TOPOLOGY
5.2. 3 PHASE, 4 WIRE, STAR
5.3. 3 PHASE, 3 WIRE, DELTA
5.4. 3 PHASE, 4 WIRE, DELTA
5.5. 3 PHASE, 3 WIRE, DELTA, 2 CT (L1-L2)
5.6. 3 PHASE, 3 WIRE, DELTA, 2 CT (L1-L3)
5.7. 2 PHASE, 3 WIRE, DELTA, 2 CTs (L1-L2)
5.8. 2 PHASE, 3 WIRE, DELTA, 2 CTs (L1-L3)
5.9. 1 PHASE, 2 WIRE
6. FUNCTIONALITIES
6.1. CT LOCATION SELECTION
6.2. SYNCHRONIZATION FUNCTIONALITY
6.3. MAINS SYNCHRONIZATION FUNCTIONALITY
6.4. SINGLE GENSET PARALLEL WITH MAINS
6.5. DC GENSET FUNCTIONALITY
6.6. AMF FUNCTIONALITY
6.7. ATS FUNCTIONALITY
6.8. REMOTE START FUNCTIONALITY
6.9. ENGINE CONTROLLER FUNCTIONALITY
6.10. REMOTE DISPLAY UNIT FUNCTIONALITY
6.11. 400HZ OPERATION
7. CONNECTION DIAGRAMS
7.1. GENSET SYNCHRONIZATION FUNCTIONALITY
7.2. MAINS SYNCHRONIZATION FUNCTIONALITY
7.3. SINGLE GENSET PARALLEL WITH MAINS FUNCTIONALITY
7.4. DC GENSET FUNCTIONALITY
7.5. AMF FUNCTIONALITY
7.6. ATS FUNCTIONALITY
7.7. REMOTE START FUNCTIONALITY
7.8. ENGINE CONTROL FUNCTIONALITY
7.9. REMOTE DISPLAY PANEL FUNCTIONALITY
8. TERMINAL DESCRIPTION
9. TECHNICAL SPECIFICATIONS
10. DESCRIPTION OF CONTROLS
10.1. FRONT PANEL FUNCTIONALITY
10.2. PUSHBUTTON FUNCTIONS
10.3. DISPLAY SCREEN ORGANIZATION
10.4. AUTOMATIC DISPLAY SCROLL
10.5. MEASURED PARAMETERS
10.6. LED LAMPS