Datalogic DS2400 User Manual

DS2400
28
2
NOTE
The auxiliary serial interface of the slave scanners can be used in
Local Echo communication mode to control any single scanner
(visualize collected data) or to configure it using the WinHost utility or
Host Mode Programming procedure.
The termination resistors of the RS485 bus must not be installed.
2.6.5 Multiplexer
Each scanner is connected to Multiplexer (for example MX4000) with the RS485 half-
duplex main interface.
1
2
3
RS485 HD Main interface
Auxiliary interface (Local Echo)
External Trigger (for On-Line mode)
Host
MX4000
0
1
31
1
2 2 2
3 3 3
LASER ON
PW R /T X D EXT TRIG
GOO D REA D
DS2400
LA SE R O N
PWR/TX D EXT TRIG
GOOD READ
DS2400
LASER ON
PWR/TXD
EXT TRIG
GOOD R EA D
DS2400
Figure 32 - Multiplexer layout
The auxiliary serial interface of the slave scanners can be used in Local Echo
communication mode to control any single scanner (visualize collected data) or to
configure it using the WinHost utility or Host Mode Programming procedure.
When On-Line Operating mode is used, the scanner is activated by an External
Trigger (photoelectric sensor) when the object enters its reading zone.

Datalogic DS2400 Specifications

General

Brand	Datalogic
Model	DS2400
Category	Barcode Reader
Language	English