v
GUIDE TO INSTALLATION
The following can be used as a checklist to verify all of the steps necessary for
complete installation of the DS2400 scanner.
1) Read all information in the section "Safety Precautions” at the beginning of this
manual.
2) Correctly position and mount the scanner for barcode reading according to the
information in par. 2.2, 2.5 and 3.4.
3) Provide correct system cabling according to the signals necessary for your
application (see all sub-paragraphs under 2.3 and 2.4). See also sub-paragraphs
under 2.6 for reference.
4) Install the Configuration Disk.
Upon successful completion of the installation, the readme.hlp file is opened,
giving details about how to get started configuring your scanner.
See also the Guide To Rapid Configuration link.
Specific parameter details are available in the Help On Line.
NOTE
Fine tuning of the scanner position for barcode reading can be
accomplished using the Test Mode as described in WinHost.
The installation is now complete.
To Next Page
Loading...
Need help?
General
