PRODUCT REFERENCE GUIDE
5
CHAPTER 2
SETUP
UNPACKING
Check carefully to ensure the reader and any cables or accessories ordered are present
and undamaged. If any damage occurred during shipment, contact "
Technical Support"
on page xiv
.
SETTING UP THE GRYPHON™ GD4500 READER
Depending on whether you are using a Corded or Wireless version of the Gryphon, fol-
low the steps provided in this section to connect and get your reader up and communi-
cating with its host:
1. Connect the Interface Cable to the reader as shown in Figure 2. To disconnect the
cable, insert a paper clip or similar object into the opening shown.
2. Connect the other end to the Host (see the next section, "
Connect Host Interface"
on page 6
and Figure 5).
3. Modify "
Customizing Configuration Settings" on page 30 (only if modifications are
needed from factory settings).
NOTE: According to Regulation for shipping Li-Ion based battery packs, the
products and their spare battery packs parts are shipped with a very low
residual charge (low state of charge).
Hence the needs:
that a new product must be fully recharged before starting to use it and
that battery packs of the stocked products GBT/GM45 and spare battery
pack parts must be periodically recharged : for instance by using a
WLC4090 base station powered up with a 12V Datalogic AC/DC adapter
(cod. 8-0935) for at least 30 minutes each 3 months.
To Next Page
Loading...
