Datalogic Gryphon GD4500 - PDF417 Set Length 1; PDF417 Set Length 2

To Next Page

To Previous Page

PDF417 ENTER/EXIT PROGRAMMING MODE

PRODUCT REFERENCE GUIDE

225

PDF417 Set Length 1

Specifies one of the bar code lengths for "PDF417 Length Control" on page 224. Length 1

is the minimum label length if in Variable Length Mode, or the first fixed length if in

Fixed Length Mode. Length includes the bar code’s data characters only. Characters can

be set from 0001 to 2,710 characters (pad with zeroes) in increments of 01. Any value

greater than 2,710 will be considered to be 2,710.

See"

Set Length 1" on page 297 for detailed instructions on setting this feature.

PDF417 Set Length 2

This feature specifies one of the bar code lengths for "PDF417 Length Control" on page

224

. Length 2 is the maximum label length if in Variable Length Mode, or the second

fixed length if in Fixed Length Mode. Length includes the bar code’s check, data, and

full-ASCII shift characters. The length does not include start/stop characters. Characters

can be set from 01 to 2,710 characters (pad with zeroes) in increments of 01. Any value

greater than 2,710 will be considered to be 2,710.

See "

Set Length 2" on page 298 for detailed instructions on setting this feature.

Select PDF417 Length 1 Setting

$CP4L1

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in Appendix D, Keypad represent-

ing your desired character(s). End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



0001 = Length 1 is 1 Character

Select PDF417 Length 2 Setting

$CP4L2