Datalogic Gryphon GD4500 - Intercharacter Delay; Intercode Delay

ENTER/EXIT PROGRAMMING MODE KEYBOARD INTERFACE
76 GRYPHON™ I GD/GBT/GM4500
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and
the beginning of the next. The delay can be set within a range of zero (0) to 990 millisec-
onds in 10ms increments. A setting of zero specifies no delay. See "
Intercharacter Delay"
on page 279
for more detailed programming instructions.
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface. The select-
able range for this feature is from 0 to 99 seconds. See "
Intercode Delay" on page 280 for
more detailed programming instructions
NOTE: This feature applies ONLY to the Keyboard Wedge interface.
$CR2IC00
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
$CR2IC
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in Appendix D,
Keypad representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

00 = No Intercharacter Delay
Set Intercode Delay
$CKBID
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

00 = No Wedge Intercode Delay