IBM Features
Product Reference Guide 117
IBM Number of Host Resets
Specifies how many consecutive resets are processed before the scanner
starts a five-second period during which a user is allowed to enter label-
programming mode and configure the scanner.
To set the number of host resets:
1. Scan the SWITCH bar code.
2. Scan the bar code,
SET IBM NUMBER OF HOST RESETS. You’ll
need to cover any unused bar codes on this and the facing page to
ensure that the scanner reads only the bar code you intend to scan.
3. Scan the appropriate digits from the keypad in
Appendix C that rep-
resent the desired number of host resets. The selectable range is 1-15
resets. Pad all single and double digit numbers with leading zeroes to
yield a three-digit entry (001-015).
Examples:
001 = 1 reset
005 = 5 resets
011= 11 resets
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned
SET IBM NUMBER OF HOST RESETS
To Next Page
Loading...
Need help?
General
