To Next Page

To Previous Page

Code 39 Enable

Product Reference Guide 293

Code 39 Length Control

This feature specifies whether variable-length or fixed-length decoding

will be set for Code 39.

To set this feature:

1. Scan the SWITCH bar code.

2. Scan your selection from the bar codes below. You’ll need to cover

any unused bar codes on this and the facing page to ensure that the

scanner reads only the bar code you intend to scan.

3. Complete the programming sequence by scanning the SWITCH

bar code.

CODE 39 LENGTH CONTROL = VARIABLE-LENGTH

CODE 39 LENGTH CONTROL = FIXED-LENGTH

NOTE

You must now set the features Code 39 Length 1 and Code 39

Length 2.

When using variable length stitching, it is important to enable Code

39 Check Character Calculation to prevent misreads.

Datalogic Magellan 2200VSΩ User Manual

Other manuals for Datalogic Magellan 2200VSΩ