EAN-8 Enable
Product Reference Guide 217
EAN-8/JAN-8 Guard Substitution
Enables/disables the ability of the scanner to substitute a guard pattern for
even-parity 6 when an EAN-8/JAN-8 label is presented.
To set this feature:
1. Scan the SWITCH bar code.
2. Scan either the enable or disable bar code below. You’ll need to cover
any unused bar codes on this and the facing page to ensure that the
scanner reads only the bar code you intend to scan.
3. Complete the programming sequence by scanning the SWITCH
bar code.
EAN-8/JAN-8 GUARD SUBSTITUTION = DISABLE
EAN-8/JAN-8 GUARD SUBSTITUTION = ENABLE
To Next Page
Loading...
Need help?
General
