To Next Page

To Previous Page

288 Magellan

2200VS/2200VS and 2300HS/2300HS

Code 39 Check Character Calculation

Enables/disables calculation and verification of an optional Code 39 check

character. When disabled, any check character in label is treated as a data

character.

To set this feature:

1. Scan the SWITCH bar code.

2. Scan either the enable or disable bar code below. You’ll need to cover

any unused bar codes on this and the facing page to ensure that the

scanner reads only the bar code you intend to scan.

3. Complete the programming sequence by scanning the SWITCH

bar code.

CODE 39 CHECK CHARACTER CALCULATION = DISABLE

CODE 39 CHECK CHARACTER CALCULATION = ENABLE

NOTE

If check calculation is disabled, the risk is increased that a misread

can occur.

In particular, if you are using variable length stitching, it is important to

use check character calculation to prevent misreads.

Datalogic Magellan 2200VSΩ User Manual

Other manuals for Datalogic Magellan 2200VSΩ