ENTER/EXIT PROGRAMMING MODE READING PARAMETERS
110
POWERSCAN™ PD/PM96XX
Image Capture
For information and a list of options for Image Capture, use the Datalogic Aladdin con-
figuration application, available for free download from the Datalogic Scanning website.
Multiple Labels Ordering by Code Symbology
This feature allows you to specify the order multiple labels are transmitted by symbol-
ogy type. This parameter is applied when the reader is configured in “Retained Trigger
hold multiple" (see
page 93). For detailed information on setting this feature, see
page 292 in “References”.
Multiple Labels Ordering by Code Length
Specifies the transmission ordering by code length, when Multiple Labels per Frame is
enabled.
Select Symbologies for Multiple Labels Ordering
$CSNMS
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by Hex values from the table on page 292 cor-
responding to the desired code symbologies. End by
scanning the ENTER/EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
000000000000 = Random order
$CSNMT00
Multiple Labels Ordering = Disable
Multiple Labels Ordering = Transmit Increasing
Length Order
$CSNMT01
$CSNMT02
Multiple Labels Ordering = Transmit Decreasing
Length Order
To Next Page
Loading...
