Datalogic RIDA DBT6400 Quick Reference Manual

Programming
16 RIDA™ DBT6400
Programming
The reader is factory-configured with a set of standard
default features. You can select other options and cus-
tomize your reader through use of the programming bar
codes available in the Product Reference Guide (PRG) or
Datalogic Aladdin™ configuration software (both available
on the Datalogic website).
Using Programming Bar Codes
This manual contains bar codes which allow you to recon-
figure your reader. Some programming bar code labels
require only the scan of that single label to enact the
change.
Other bar codes require the reader to be placed in Pro-
gramming Mode prior to scanning them. Scan an ENTER/
EXIT bar code once to enter Programming Mode; scan the
desired parameter settings; scan the ENTER/EXIT bar
code again to accept your changes, which exits Program-
ming Mode and returns the reader to normal operation.
Configure Other Settings
Additional programming bar codes are available to allow
for customizing programming features, if your installation
requires different programming than the standard factory
default settings. Refer to the PRG or to the Datalogic
Aladdin™ configuration software.
Resetting Standard Product Defaults
Refer to the PRG for a listing of standard factory settings.
If you aren’t sure what programming options are in your
reader, or you’ve changed some options and want the fac-
tory settings restored, scan the bar code below to copy the
factory configuration for the currently active interface to
the current configuration.
Standard Product Default Settings

Datalogic RIDA DBT6400 Specifications

General

Scanner type	Handheld scanner
Type	Handheld bar code reader
Wavelength	650 nm
Sensor type	-
Yaw reading angle	-60 - 60 °
Tilt reading angle	0 - 360 °
Pitch reading angle	-65 - 65 °
Linear (1D) barcodes supported	JAN, PostBar, RM4SCC / KIX
2D (matrix & stacked) barcodes supported	Aztec Code, Composite Codes, Data Matrix, GS1 DataBar Expanded Stacked, GS1 DataBar Stacked Omnidirectional, Han Xin, MaxiCode, Micro QR Code, MicroPDF417, QR Code
Wireless range	25 m
Bluetooth version	4.0
Operating frequency	2400 MHz
Standard interfaces	Bluetooth, USB
Connectivity technology	Wired & Wireless
Battery life	5 h
Charging time	2.5 h
Battery capacity	700 mAh
Power source type	Battery
Number of reads per charge	3000
Number of batteries supported	1
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Product color	White
International Protection (IP) code	IP50
Sustainability certificates	RoHS
Cables included	No
Harmonized System (HS) code	84716070

Weight and Dimensions

Depth	42.3 mm
Width	112.5 mm
Height	27.5 mm
Weight	85 g