Datamax Mark II M-4206 User Manual

M-Class 11
5. Close the Printhead Assembly and press down until it locks into place.
6. Close the cover and press the
FEED
button several times to position the media and ensure proper tracking.
If the printer does not correctly sense the top of each label, as denoted by the
ERROR
light, it may be necessary to:
Printers without front display: Perform the Auto Media Sensor Calibration, see section 4.7.1.
Printers with front display: Press and hold the
FEED
button until at least one label gap or mark is advanced then
release. For additional calibration procedures, see section 5.4
 Note: The printer is factory set to use 4-inch media (and ribbon, if thermal transfer equipped). When using a different width of
media/ribbon, please refer to section 6.2.

Datamax Mark II M-4206 Specifications

General

Print Resolution	203 dpi
Type	Label Printer
Print Method	Thermal Transfer
Max Print Speed	6 inches per second
Memory	16 MB SDRAM, 8 MB Flash
Interfaces	USB, Serial, Parallel
Media Width	4.5 inches
Media Length	0.25" to 99"
Max Print Width	4.25 inches (108 mm)