10
2.3.1 Loading for Presenter Mode
The printer must be configured for use in “Presenter Mode”. See section 3.5 for connecting and
configuring the printer’s settings.
1) Load media as described in Section 2.3, (steps 1-3).
2) Remove about 8 inches (200mm) of labels from the Media Backing.
3) Open the Peeler Door. Route the media as shown below.
312
Media Backing
Peeler Door
4) Pull the media backing taught then Close the Peeler Door.
5) Press the
button a couple of times to normalize tracking. The printer should advance the media to
the start of the next label for each press.
To Next Page
Loading...
Need help?
General