To Next Page

To Previous Page

3.4.2 Quick Media Calibration

The printer is factory calibrated for operation with most media types (both gap and black mark). Try your

media without performing any calibration adjustments first, this will determine if the factory settings are

compatible. Only perform the calibration adjustments if you are experiencing media registration issues.

The Quick Media Calibration should be performed first, if it fails to detect your label media proceed to the

Manual Media Calibration procedure, see section 3.4.3.

The Quick Media Calibration can be performed using the NETira CT configuration utility, (see section 3.3

for more information on NETira CT).

Launch the NETira CT configuration utility, and query (connect) to the printer.

1) Click on the ‘Sensor Calibration’

printer component.

2) Install your media in the

printer and click the ‘Quick

Media’ button.

3) The printer will feed media

while the sensor is being

calibrated. At the end of the

process the following message

will be shown, indicating a

successful calibration. Values

displayed in the “New Value”

column may change after a

calibration.

If the calibration is not

successful, repeat the

procedure. If the Quick Media

calibration continues to fail,

proceed to section 3.4.3

Manual calibration

Datamax RL4 User Manual

Other manuals for Datamax RL4