Datamax RL4 - B.4.2 WPA2-PSK CCMP Security; B.4.3 WPA2-PSK TKIP Security

B-4
B.4.2 WPA2-PSK w/CCMP
1) Click on the ‘WIFI’ printer
component.
2) Click the ‘Click the WPA/WPA2’
radio button.
3) Change (or confirm) the
following parameter settings:
Group Cipher: CCMP
Network Authentication Type:
WPA2-PSK
4) Type the Pass Phrase under the
“WPA_PSK_TKIP/ WPA2_PSK
settings” section. Note that Pass
Phrase is case sensitive.
5) After updating the “New Value”
column, click on the check box
to select these parameters
to be sent to the printer. Click
the Send button to send these
changes to the printer.
B.4.3 WPA2-PSK w/TKIP
1) Click on the ‘WIFI’ printer
component.
2) Click the ‘Click the WPA/WPA2’
radio button.
3) Change (or confirm) the
following parameter settings:
Group Cipher: TKIP
Network Authentication Type:
WPA2-PSK
4) Type the Pass Phrase under the
“WPA_PSK_TKIP/WPA2_PSK
settings” section. Note that Pass
Phrase is case sensitive.
5) After updating the “New Value”
column, click on the check box
to select these parameters
to be sent to the printer. Click
the Send button to send these
changes to the printer.