B-5
B.4.4 WPA2-Enterprise
1) Click on the ‘WIFI’ printer
component.
2) Click the ‘Click the WPA/WPA2’
radio button.
3) Change (or confirm) the
following parameter settings:
Network Authentication Type:
WPA-Enterprise
Phase 2 Method: EAP-MSCHAPv2
EAP Type: Select EAP-PEAP
Note: EAP Type can be variable.
Other values supported: EAP-LEAP,
EAP-TTLS, EAP-PEAP, EAP-FAST
4) Type the user name and
password under the “WPA/WPA2
Enterprise” section.
5) After updating the “New Value”
column, click on the check box
to select these parameters
to be sent to the printer. Click
the Send button to send these
changes to the printer.
To Next Page
Loading...
