31
3) Close the Cover and then Press the button several times until the cleaning card has been
completely fed through the printer.
Cleaning Card
Cover
Feed Button
4) Reload the media. Close the Cover, push down until it latches closed. Press the
button to
normalize tracking.
To clean the printhead (using Datamax-O’Neil Cleaning Pen #770172-000):
The Cleaning Pen is typically intended for use on linerless model printers. It is used to clean components
that are exposed directly to adhesive. The pen is dual-sided and has a two-step process. The first step
“Step 1” breaks up the adhesive and the second step “Step2” removes it.
STEP 1 STEP2
The “Step 2” end cap has a plastic scraper to remove large
build-ups of adhesive from plastic and metal parts.
DO NOT USE ON THE PRINTHEAD OR SENSORS.
To Next Page
Loading...
Need help?
General