Datasat AP25 - The Menu Button; System Setup Screen

AP25 Installation and Operating Guide Page 51
AP25 Installation & Operating Guide Document # 9301H79500 Ver. 1.00
4.1 The Menu Button
The Menu Button is intended to be used by theater technicians only. Password protection is highly
recommended.
Selecting the
button, after first powering up the AP25, will display the System Setup screen.
This will provide access to the Setup menus.
In the next section, we will discuss in detail the options available through the menu bar. Pressing the
Home button will take you back to the Home or Main screen.
4.2 System Setup Screen
Menu (System) > System Setup
Figure 23. System Setup Screen
The following options are available directly from this screen.
ScreenSaver Time - Options include a 10 second delay, 1 minute delay, or 5 minute delay
before screen saver initiates.
ScreenSaver Mode - Disabled, Dim Screen, Graphic, or Black screen.
 Disabled will turn off the screen saver.
 Dim Screen will reduce the LCD brightness after the time specified in the ScreenSaver
Time drop-down menu. Touching the screen or turning the adjustment knob will
restore the brightness.
 Graphic mode uses the stored screen saver graphic. Touching the screen or turning the
adjustment knob will restore the Home screen.
 Black Screen will black out the screen after the specified time selected under Screensaver
Time.
LCD Brightness -Use the on-screen slider or the adjustment knob to adjust the brightness of
your LCD screen.
Turn adjustment
knob to adjust
brightness